It is a UJ pirogue I used 1/4 Luan plywood. The rub rails are 3/4 wide 1-3/4 tall and 16 foot long. The grain runs with the boat. They seem to fit pretty good until I get to the bow and stern. I think I'm gonna rip them down to 1/2 wide 1-1/4 tall I do plan on adding inside spacers with...
Need some help I'm trying to do my rub rails. Im using 1-3/4 x 1/4 I ripped from a sixteen foot 2x4 but clamping them up to the boat they seem to be to siff and rigid. I was thinking about ripping them again to 1-3/4x1/2. Any info from builders would be helpful.
Thanks
Outlaw
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.